Drillholes intersecting a defined section at depth are not displayed, even when assigning a wide envelope width.

Solution


Make sure you check the “Show holes intersecting at depth” box in the Define New Section or Plan dialog. Any
holes that intersect the drillhole envelope at depth should then be displayed on your section. If this
box is not checked only drillholes which are collared within the section envelope will be displayed
on your section.

Would you like to...

Print this page Print this page

Email this page Email this page

Post a comment Post a comment

Subscribe me

Remove Highlighting Remove Highlighting

Edit this article

User Opinions (1 vote)

0% thumbs up 100% thumbs down

How would you rate this article?




Thank you for rating this article.
21st August 2012 12:51:07 pm

Related Articles

Attachments

No attachments were found.